Throttle Postition Sensor Adjustment:
For this modification you need to put the bike into Diagnostic Mode:
To access DIAG mode:
Switch off Engine Run switch, switch OFF Key switch. Press both SELECT & RESET buttons and then switch ON Key switch. Keep SELECT & RESET buttons pressed for at least 8 seconds. Display then changes to "DIAG". Release SELECT & RESET buttons. Select Diag mode by pressing again both SELECT & RESET buttons. Select code below by pressing SELECT (up) or RESET (down).
On the digital display select 01 (throttle position) and make a note of the number on the screen. It should be between 15 - 17.
Now locate the throttle sensor, its on the left hand side of the bike behind the cylinder.
Slacken the two bolts on the sensor
If you rotate the sensor clockwise/ anti clockwise you will see the number of the digital display increase and decrease.
Increase the value to 26 (max is 27).
DISCLAIMER: YOU DO THIS AT YOUR OWN RISK AND MAY VOID THE MANUFACTURERS WARRANTY.
| Content © Yam-XT.com 2006 |